『Flow meter PPT』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. Types and principles of flow meters
There are many types of flow meters, mainly including vortex flow meters, turbine flow meters, electromagnetic flow meters, ultrasonic flow meters, etc. The following is a detailed introduction to various flow meters and their principles.
1. Principle of vortex flow meter: When fluid flows in a pipeline, vortex vibration is generated under specific conditions, which is related to the velocity of the fluid.
. The vortex flowmeter measures the flow rate of a fluid by inducing this vibration. Based on the principle of fluid dynamics, when a fluid flows in a pipeline, it drives the turbine to rotate, and the speed of the turbine is proportional to the flow velocity of the fluid. The wide sliding mode can calculate the fluid flow rate by measuring the speed of the turbine. 3. The principle of electromagnetic flowmeter is based on the electromotive force generated when a conductive liquid flows in a magnetic field. When a fluid flows through an electromagnetic field, an induced electromotive force is generated, which is proportional to the average flow velocity of the fluid. By measuring this electromotive force, the flow rate of the fluid can be determined.4. Principle of ultrasonic flowmeter: The flow rate can be calculated by measuring the time that ultrasonic waves propagate in a slow-moving body.
. When ultrasound propagates in a flowing fluid, its propagation time varies with changes in fluid velocity. By measuring this time difference and combining it with the sound velocity of the fluid, the flow rate of the fluid can be calculated. The above flow meters each have their own characteristics and applicable scenarios. The selection of which type of flow
2. How to use a flowmeter to adjust flow
1. A simple flowmeter cannot adjust flow because it does not have an actuator.
.2、 Automatic flow control can be achieved through three components: flow meter, PID regulator, and regulating valve.
3、 Enter the desired flow rate value and the old value on the PID controller. The PID controller only controls the opening of the regulating valve to adjust the flow rate. The real-time flow signal detected by the flowmeter is fed back to the PID controller through rolling training. The three form a closed-loop control loop to achieve accurate control.
3. What do you know about the three commonly used flow meters and their working principles?
The three commonly used flow meters are electromagnetic flow meters, turbine flow meters, and vortex flow meters. Their working principles and characteristics are as follows: The working principle of electromagnetic flow meters is based on Faradays law of electromagnetic induction.. The conductive medium inside the measuring tube is equivalent to a conductive metal rod in Faradays test, with two electromagnetic coils at the upper and lower ends generating a constant magnetic field. When a conductive medium flows through, an induced voltage is generated, which is measured by two electrodes inside the pipeline. The Qihe measurement pipeline achieves electromagnetic isolation from the fluid and measurement electrodes through non-conductive lining (such as rubber, Teflon, etc.). Job characteristics: Equipped with a bidirectional measurement system. The straight pipe section required for the sensor is relatively short,
Hot Blog
Related AD
